0.1mm layer height… vs .06mm layer height battle!
Y’all Yoda’d-out yet? Hope not, because Yoda!

Yoda Lite at 0.06mm layer height. The fringing on his left ear and the hole at the top of the head were also present on the 0.1mm print. One day when I’ve got another extruder printing support material these problems will go away. It’s impressive to me that overhangs like the left ear actually print in the first place.
After a bunch of testing and tweaking (lowered the “XY jerk” setting in the marlin firmware, lowered the hot end temp to 222ºC, raised the bed temp to 110ºC, increased filament retraction to 1.5mm) I got the bot printing .1mm layers with 180mm/sec perimeters, and proceeded to print a full-scale Yoda Lite as a test –this time completely hollow to save time and plastic. I was shocked to see in this print facial details that were not at all visible in the .2mm layer-height version. Night and day. He has eyes, and eyelids, with wrinkles! It almost looked like there was skin surface. 0.1mm layers are so small they begin to disappear.
But if it could print at 0.1mm, what about lower? How about the arbitrarily-chosen height of 0.06mm? Apparently yes, it’s possible. It worked. The layers are so barely-there that other very fine layers that run vertically and wrap around the contours of the object have become visible –I think they may be evidence of the limits of the resolution of the x and y axes.
I’d given away the 0.1mm Yoda to a cousin and can’t compare the two directly, but I had taken a couple of very similar photos, and after adjusting their levels to bring out the detail the .1mm and .06mm version look pretty similar. Click either photo to view at full resolution. I should probably just print another .1mm Yoda so I can compare them with my own eyes and see whether it’s worth printing at below .1mm layer height.
In any case, there are plenty of areas of improvement in all of these prints, but I’m very happy with the progress of my bot’s print quality. Fun.


